busa1b.jpg
823 hits | 88.55 KB | Posted: 9/12/06
By Arthur Jensen

[b]Blingin' Billet Bezel: We Install a PPM Custom's Chrome Billet 'Busa ...

busa2.jpg
473 hits | 74.29 KB | Posted: 9/12/06
Start by removing the three Allen screws that hold the lower half of the inner fairing to the bike.

busa3.jpg
451 hits | 73.56 KB | Posted: 9/12/06
Release the pins that hold the inner fairing to the windscreen supports by pushing in the center wit...

busa4.jpg
457 hits | 85.43 KB | Posted: 9/12/06
From the top, carefully pull the inner fairing away from the bike. The lower edge fits into the fra...

busa5.jpg
514 hits | 105.17 KB | Posted: 9/12/06
The stock 'Busa bezel is held on with two Phillips screws along the bottom edge and double sided tap...

busa6.jpg
593 hits | 99.25 KB | Posted: 9/12/06
Since the bezel is still attached by the double-sided tape, you will have to pry it up carefully to ...

busa7.jpg
1488 hits | 83.13 KB | Posted: 9/12/06
Before mounting the PPM Custom billet bezel with the provided adhesive, set the new part in place to...

busa8.jpg
533 hits | 90.58 KB | Posted: 9/12/06
To permanently mount the bezel, peel the cover-strips off the double-sided tape on the back of the P...

busa9a.jpg
485 hits | 80.96 KB | Posted: 9/12/06
Once the screws are tight, install the new foam weather seal around the bottom and sides of the beze...

busa9b.jpg
472 hits | 100.3 KB | Posted: 9/12/06

busa10a.jpg
555 hits | 101.14 KB | Posted: 9/12/06
Next, install the inner fairing. Starting from the rear of the fairing pieces, work your way forward...

busa10b.jpg
430 hits | 77 KB | Posted: 9/12/06

busa11.jpg
1258 hits | 69.62 KB | Posted: 9/12/06
To install the pins that hold the inner fairing to the windscreen supports you must first reset them...

busa12.jpg
486 hits | 78.3 KB | Posted: 9/12/06
Now that the fairings are in place, tighten all three Allen screws.

busa13.jpg
913 hits | 118.49 KB | Posted: 9/12/06
Seen side-by-side, the stock and PPM bezel are quite a contrast. While the stock part’s faux-carb...